: +91-84279-90176, +91-84276-00760
0
0

Common Grinding Mistakes That Everyone Do

Published On: Jan 10, 2022 by Endico Power Tools

The life-span of a building’s material flooring depends on its preservations. Its provision can be compassed by adopting two methods, polishing and grinding. These methods can keep your floor in impeccable condition. While polishing concrete, surface preparation where the majority of work takes place is very important. But many times, people often make blunders while grinding the floor and end up damaging it or gets injured. We have covered some of the mistakes that workers and contractors do while and grinding the concrete floors.

Mistake-1
RUNNING GRINDER UNNECESSARILY FAST:
It might be easy to run the grinder at its apex speed. But this extra friction is not sufficient to remove enough material. By reducing the speed of the grinder, the friction can be managed and it increases the amount of material being removed. To get the perfect result, the operator should find the perfect spot between floor hardness, diamond hardness, and grinding RPM.

Mistake-2
CONTACT WITH WHEEL
Angle grinders can cut over stone, concrete, metal and other strong materials, so while working with it you have to be ancillary careful as it can easily cut through human flesh and bones. Hence, it can have deliberate consequences and the chances of injuries increase with imprudent use of a grinder and when there are no safety precautions during its use. So, make sure the safety guard is in place and workers wear suitable gloves o keep a good grip during use. Also, be conscious while using an angle grinder. .

Mistake-3
NOT INSPECTING THE FLOOR BEFORE GRINDING:
From steel, brass to glass, a metal bond diamond can grind anything as long as the floor is good to work with. The material of the floor should not be raised above its surface. So, make sure you inspect the floor before working on it. If you do not inspect it and deal with material above the surface, you will most likely knock your diamond segment off or can do a lot of damage to the machine.

Mistake-4
USING WRONG EQUIPMENT AND POWER SOURCE:
Just like other appliances, the correct power source is important to ensure the safety of workers and equipment. While grinding concrete outdoors, you will be required to have an engine-powered grinder because electric-powered won’t work in a location with no electric outlets. These electric powered machines are fine for the indoor location as long as the correct power source is available.
It is important that the power source can support the machine. Otherwise, you can risk serious damage to the machine.

Mistake-5
PERFORM OPERATIONS WRONG:
Grinding requires specific movements. It is a bit difficult to achieve an even finish. Grinding requires smooth, repetitive, back and forth motions to achieve the perfect result. People often make this mistake while working as they work on a single spot for too long which results in damaging the equipment. Now, after reading these common mistakes, you can know your flaws while grinding. Don’t allow the complexities of working with concrete flooring overwhelm you. Just use your skills and you will get the perfect results. If you are planning to buy a concrete grinder, browse through our website. At ENDICO you can find the best industrial products like power tools and hand tools online from the best of the brands.
Recent Updates

Address

  • B-29, Had Bast No. 259,
    Industrial Area – C,
    Sarpanch Colony,
    Jaspal Banger, Ludhiana – 141122,
    Punjab, India

  • enquiry@endicopowertools.com

  • +91-84279-90176, +91-84276-00760

Company

Customer

Information

Need Help ?

© 2024 Endico Power Tools | All Rights Reserved